How To Pair Your Plantronics Voyager With The BT600 USB Adapter

If your Plantronics Voyager headset came unpaired from the BT600, this guide will show you how to fix that. 

Step 1

With the BT600 USB Adapter plugged into your laptop or computer, press and hold the button on the side of the BT600 for 3-5 seconds. The BT600 will start flashing red and blue, indicating that it's in pairing mode.

Note* The button is quite small, so we recommend using something like a paperclip or pen tip to hold down the button!

Step 2

On your Voyager 4210 or Voyager 4220 headset, there's a Bluetooth pairing button.

Hold the pairing button in the upwards position, until you hear a voice within the headset say "Pairing", or until you see a red/blue LED light start to flash where you see the power/Bluetooth button show in the image below.

Note* You'll want to do this step while the BT600 is flashing red and blue

If the steps for pairing were successful, the Plantronics BT600 will turn blue, and the headset is now connected!

If you need further assistance, contact us today!